Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
atmel:giant_lcd_shield [2013/06/21 13:22] – minerva9 | atmel:giant_lcd_shield [2013/06/22 10:13] – minerva9 | ||
---|---|---|---|
Line 18: | Line 18: | ||
=== LCD Details === | === LCD Details === | ||
- | [[http:// | + | [[http:// |
LCD has a contrast adjustment slider. Unlike many other LCDs, this one has good readability in bright sunlight. | LCD has a contrast adjustment slider. Unlike many other LCDs, this one has good readability in bright sunlight. | ||
Line 66: | Line 66: | ||
* Solder pins in place. Be careful, the pins are pretty close to each other. Check for any shorting as you go. | * Solder pins in place. Be careful, the pins are pretty close to each other. Check for any shorting as you go. | ||
* Close the LCD connector - best to use a small screwdriver to do this | * Close the LCD connector - best to use a small screwdriver to do this | ||
+ | * Finish tightening the screws into the standoffs | ||
Line 105: | Line 106: | ||
<code c> | <code c> | ||
#include < | #include < | ||
+ | //Compiled with Arduino Version 1.0.5 | ||
//We are using Arduino Uno pins 3 (Receive) and 4 (Transmit) | //We are using Arduino Uno pins 3 (Receive) and 4 (Transmit) | ||
//This demo actually just uses pin 4 - there is no reception of data | //This demo actually just uses pin 4 - there is no reception of data | ||
Line 125: | Line 127: | ||
//Clear LCD display, set font to 0 and position cursor at top LHS of display | //Clear LCD display, set font to 0 and position cursor at top LHS of display | ||
//note that we need two ' | //note that we need two ' | ||
- | mySerial.print(" | + | |
delay (2000); | delay (2000); | ||
- | goto x; | + | |
mySerial.print(" | mySerial.print(" | ||
// | // |