atmel:giant_lcd_shield

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
atmel:giant_lcd_shield [2013/06/21 13:24] minerva9atmel:giant_lcd_shield [2013/06/21 13:52] minerva9
Line 66: Line 66:
   * Solder pins in place. Be careful, the pins are pretty close to each other. Check for any shorting as you go.   * Solder pins in place. Be careful, the pins are pretty close to each other. Check for any shorting as you go.
   * Close the LCD connector - best to use a small screwdriver to do this   * Close the LCD connector - best to use a small screwdriver to do this
 +  * Finish tightening the screws into the standoffs
  
  
  • atmel/giant_lcd_shield.txt
  • Last modified: 2013/06/23 11:56
  • by minerva9