Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
livebox:hah_hahnode:airwick [2012/05/22 12:11] – [Assembly instructions for the Airwick] minerva9 | livebox:hah_hahnode:airwick [2012/05/23 12:55] – [Assembly instructions for the Airwick] minerva9 | ||
---|---|---|---|
Line 37: | Line 37: | ||
|| There are three wires that need to be soldered onto the Airwick PCB. These connect power/ | || There are three wires that need to be soldered onto the Airwick PCB. These connect power/ | ||
|| We cut away the plastic part that used to hold the canister. This allows better access to the HAHnode PCB.\\ Initially I left too much tube, the arrow shows where to cut, I used a hacksaw, just above the tongues. || {{6783272238_1202d4a576_b.jpg? | || We cut away the plastic part that used to hold the canister. This allows better access to the HAHnode PCB.\\ Initially I left too much tube, the arrow shows where to cut, I used a hacksaw, just above the tongues. || {{6783272238_1202d4a576_b.jpg? | ||
- | || Wire up the LDR sensor. Don't forget to fit the little white grommet - this makes for a nicer finish when the LDR is mounted in the Airwick case. || {{http:// | + | || Wire up the LDR sensor. Obviously, polarity of the connection is unimportant. Don't forget to fit the little white grommet - this makes for a nicer finish when the LDR is mounted in the Airwick case. || {{http:// |
|| Wire up the DS18B20 Temp sensor. The insulation tube that is supplied is heatshrink. A quick blast from your heatshrink gun (or a paint stripper gun) will do the job. || {{6783273502_f2bfcdaa68_b.jpg? | || Wire up the DS18B20 Temp sensor. The insulation tube that is supplied is heatshrink. A quick blast from your heatshrink gun (or a paint stripper gun) will do the job. || {{6783273502_f2bfcdaa68_b.jpg? | ||
|| Attach sensors || {{6929391161_584aa1d219_b.jpg? | || Attach sensors || {{6929391161_584aa1d219_b.jpg? |