Differences

This shows you the differences between two versions of the page.

--- livebox:hah_hahnode:outputnode [2015/01/24 23:21] – brett
+++ livebox:hah_hahnode:outputnode [2015/02/03 09:51] – [Debugging] brett
@@ Line 5: / Line 5: @@
 {{:livebox:output-node-sequence-diagram.png|}}
-Snippet of configuration information needed in the jeenodeApplet.lua source.
+Snippet of configuration information needed in the jeenodeApplet.lua source.  Here we are sending to an RF node configured as unit 7.
 <code>
 OutputNode = require("xap.outputnode")
 local nodes = {
-  [ID]=OutputNode{instance="jeenode:attic",endpoints={p1=1,p2=1,p3=1,p4=1}}
+  [7]=OutputNode{instance="jeenode:attic",endpoints={p1=1,p2=1,p3=1,p4=1}}
 }
 </code>
@@ Line 69: / Line 69: @@
 </code>
+====== Debugging ======
+Flash the HAHCentral and Output nodes sketches, tethering each to your computer.
+Connect to each @ 57600 baud.
+When powered on the following should be displayed
+<code>
+[HAHCentral.1]1 g212 @ 868Mhz
+OK 8 0
+</code>
+<code>
+[outputNode.1] i8 g212 @ 868Mhz
+OUTPUT 0 0 0 0 0
+</code>
+Entering a command on the HAHCentral to toggle a Port on and off.  The command will not be displayed as its typed into the sketch terminal window.
+Enter command 1,1,8s (PORT 1,ON,NODE 8) then 1,0,8s (PORT 1,OFF,NODE 8)
+<code>
+[HAHCentral.1]1 g212 @ 868Mhz
+OK 8 0
+> 8s
+ -> 2 b
+> 8s
+ -> 2 b
+</code>
+The sketch will display "> 8s" when the "s" letter is sent, no CR/LF is necessary.  The next line "-> 2 b" indicates that two bytes of data where transmitted.
+The output on the other side will now look like this:
+<code>
+[outputNode.1] i8 g212 @ 868Mhz
+OUTPUT 0 0 0 0 0
+GOT 1 1
+Port 1 set on
+GOT 1 0
+Port 1 set off
+</code>