Differences

This shows you the differences between two versions of the page.

--- livebox:hah_hahnode [2014/01/20 09:01] – [Output Node] brett
+++ livebox:hah_hahnode [2014/01/20 09:02] – [Infrared Receiver node] brett
@@ Line 351: / Line 351: @@
-===== Infrared Receiver node =====
-Block diagram of how the IRnode fits into the system
-{{:livebox:irnode-block-diagram.png}}
-{{ :livebox:35200_pv.jpg?200}} By attaching a Infrared receiver to a JeeNode unit we can relay the signal transmitted from the Remote Control to the HAH and produce an xAP message.  This message then becomes the hook for //User Applet// scripts to attach and take action.
-Typical configuration in the JeeNodeApplet.lua
-<code>
-IRNode = require("xap.irnode").IRNode
-...
-local nodes = {
-   [2] = IRNode{instance="jeenode:ir"},
-}
-</code>
-This configures the JeeNode with ID of 5 and with an attached IR sensor to relay messages, via RF, to the HAH unit.
-The IR sensor data pin is connected to
-^^ Port ^^ Type ^^ Arduino ^^ Signal ^^ Chip ^^
-|| Port 2 || DIO || Digital 5 || PD5 || pin 11 ||
-Once the IRnode.pde sketch is loaded onto your jeenode and the HAH is correctly configured, pressing a button on your remote control should produce a message like this.
-<code>
-xap-header
-{
-uid=FF08DBFE
-source=dbzoo.livebox.jeenode:ir
-hop=1
-class=IR.Comms
-v=12
-}
-ir.received
-{
-value=550717623
-type=1
-bits=32
-}
-</code>
-Note that this configuration is better suited to a JeeNode that is not battery powered.
 ====== Nodule I/O pins ======