livebox:hah_i2c

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
livebox:hah_i2c [2011/12/31 19:24] – [Firmware debugging] brettlivebox:hah_i2c [2011/12/31 19:27] – [Firmware debugging] brett
Line 131: Line 131:
 </code> </code>
  
-The firmware command "i2c scan" is VERY useful when making sure that the hardware is correctly setup and configured.  This can only be issued with a direct microcom connection to the AVR running in DEBUG mode.  See also [[hah_microcontroller]]+The firmware command "''i2c scan''" is VERY useful when making sure that the hardware is correctly setup and configured.  Issuing this command will perform a scan of ALL I2C addresses from 0x00-0xFF to see what responds.  You can only run this with direct microcom connection to the AVR running in DEBUG mode.  See also [[hah_microcontroller]]
  
 ===== xAP control ===== ===== xAP control =====
  • livebox/hah_i2c.txt
  • Last modified: 2011/12/31 19:31
  • by brett