Differences

This shows you the differences between two versions of the page.

--- livebox:hah_installation [2012/05/09 12:55] – [Installing the HAH firmware] minerva9
+++ livebox:hah_installation [2016/07/23 15:35] (current) – [Locating DHCP assigned IP] minerva9
@@ Line 13: / Line 13: @@
 <note tip>
-If you find the idea of reflashing your Livebox too daunting, you can buy a pre-flashed HAH from http://www.homeautomationhub.com
+If you find the idea of reflashing a Livebox too daunting, you can buy a pre-flashed HAH from http://www.homeautomationhub.com
 </note>
@@ Line 30: / Line 30: @@
 **The HAH uses DHCP by default**.
-There are a couple of way to find out what IP address has been assigned
+There are a few ways to find out what IP address has been assigned
   * You can examine your DHCP server and look for the lease.
   * With the additional hardware the IP address is shown on the LCD at boot up.
   * Install the xFx_Viewer and look for the IP address on any xAP heartbeat being emitted or obtained directly from the encoding of the HUB source path. Such as shown below.
-<note important>[[http://www.edjo.pwp.blueyonder.co.uk/edward/xAP/downloads/xFx%20Viewer%20Installer.msi|xFxViewer v4]] requires the [[http://www.edjo.pwp.blueyonder.co.uk/edward/xAP/downloads/xFx-Express%20Hub%20Installer.msi|Express hub]] to also be installed.\\  [[http://www.edjo.pwp.blueyonder.co.uk/edward/xAP/downloads/xFx%20Viewer%20Installer.msi|xFxViewer v3]] does not so its a simpler installation process.</note>
+<note important>[[http://www.dbzoo.com/public/xFx%20Viewer%20v4%20Installer.msi|xFxViewer v4]] requires the [[http://www.edjo.pwp.blueyonder.co.uk/edward/xAP/downloads/xFx-Express%20Hub%20Installer.msi|Express hub]] to also be installed.\\  [[http://www.dbzoo.com/public/xFx%20Viewer%20Installer.msi|xFxViewer v3]] does not so its a simpler installation process.</note>
 {{:livebox:locating-ip-with-xfx.jpg|}}