This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision |
livebox:sms [2012/05/18 23:58] – brett | livebox:sms [2014/06/08 10:37] (current) – minerva9 |
---|
Testing was done using a NOKIA-7110 your mileage may vary with other handsets. However if they are compatible with the COMMAND SET then they **should just work**. | Testing was done using a NOKIA-7110 your mileage may vary with other handsets. However if they are compatible with the COMMAND SET then they **should just work**. |
| |
Connecting the phone to the Livebox will requires a [[http://www.homeautomationhub.com/content/dlr3-connect-cable|DLR-3 cable]] and a USB/Serial cable. | Connecting the phone to the Livebox will requires a [[http://www.homeautomationhub.com/content/dlr3-connect-cable|DLR-3 cable]] and a [[http://www.homeautomationhub.com/content/usb-serial-adaptor|USB/Serial cable]]. |
| |
Note that xap-sms connects at 19200 baud. | Note that xap-sms connects at 19200 baud. |
</code> | </code> |
| |
There are three configuration parameters in ///etc/xap-livebox.ini// that xap-sms honours. Whether the daemon should be started or not and the USB serial device where the phone can be found. These can also be updated via the WEB interface. | There are three configuration parameters in ///etc/xap-livebox.ini// that xap-sms honours. Whether the daemon should be started or not, the USB serial device where the phone can be found and the baud rate for the serial comms. These can also be updated via the HAH web interface. |
| |
<code> | <code> |