Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
livebox:sms [2012/05/15 11:36]
minerva9
livebox:sms [2014/06/08 10:37] (current)
minerva9
Line 7: Line 7:
 Testing was done using a NOKIA-7110 your mileage may vary with other handsets. ​ However if they are compatible with the COMMAND SET then they **should just work**. ​ Testing was done using a NOKIA-7110 your mileage may vary with other handsets. ​ However if they are compatible with the COMMAND SET then they **should just work**. ​
  
-Connecting the phone to the Livebox will requires a [[http://​www.homeautomationhub.com/​content/​dlr3-connect-cable|DLR-3 cable]] and a USB/Serial cable.+Connecting the phone to the Livebox will requires a [[http://​www.homeautomationhub.com/​content/​dlr3-connect-cable|DLR-3 cable]] and a [[http://​www.homeautomationhub.com/​content/​usb-serial-adaptor|USB/Serial cable]].
  
-Note that xap-sms connects at 19200baud.+Note that xap-sms connects at 19200 baud.
  
 The command line options: The command line options:
Line 19: Line 19:
  
 xap-sms: [options] xap-sms: [options]
-  -n, --instance NAME    Default sms 
   -i, --interface IF     ​Default br0   -i, --interface IF     ​Default br0
-  ​-p, --port NUM         ​Default 3639 +  -d, --debug ​           0-7
-  -s, --serial DEV       ​Default /​dev/​ttyUSB1 +
-  ​-d, --debug ​           0-9+
   -h, --help   -h, --help
 </​code>​ </​code>​
Line 63: Line 60:
 </​code>​ </​code>​
  
-There are two configuration parameters in ///​etc/​xap-livebox.ini//​ that xap-sms honours. ​ Whether the daemon should be started or not and the USB serial device where the phone can be found. ​ These can also be updated via the WEB interface.+There are three configuration parameters in ///​etc/​xap-livebox.ini//​ that xap-sms honours. ​ Whether the daemon should be started or notthe USB serial device where the phone can be found and the baud rate for the serial comms.  These can also be updated via the HAH web interface.
  
 <​code>​ <​code>​
Line 69: Line 66:
 enable=1 enable=1
 usbserial=/​dev/​ttyUSB1 usbserial=/​dev/​ttyUSB1
 +baud=19200
 </​code>​ </​code>​