livebox:xap_adapter

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revisionBoth sides next revision
livebox:xap_adapter [2011/12/18 18:22] – [xAP Adapter] brettlivebox:xap_adapter [2012/03/04 09:53] – [1-Wire] Copied 1wire information from 305 release notes karl
Line 4: Line 4:
  
 <code> <code>
 +# xap-livebox --help
 Livebox Connector for xAP Livebox Connector for xAP
 Copyright (C) DBzoo, 2008-2010 Copyright (C) DBzoo, 2008-2010
Line 63: Line 64:
 Each sensor can be given a label using the nomenclature "sensor#.label=<your label>" These are best setup using the WEB interface but can be done manually too. The assigned label will be included in the xAP message that is generated when the temperature changes. The 'displaytext' tag will have the format 'displaytext=<label> <temperature>' e.g. displaytext=Inside 21.0 Each sensor can be given a label using the nomenclature "sensor#.label=<your label>" These are best setup using the WEB interface but can be done manually too. The assigned label will be included in the xAP message that is generated when the temperature changes. The 'displaytext' tag will have the format 'displaytext=<label> <temperature>' e.g. displaytext=Inside 21.0
  
 +1wire devices can be setup with a calibration (offset) and hysteresis.   This allows you to adjust the reading from each device to allow for variances in their readings.  The hysteresis is used to prevent jitter from the devices triggering an event message.  The offset may be positive or negative.  The hyteresis is a postive.  Both values are floating point.
  
  • livebox/xap_adapter.txt
  • Last modified: 2012/03/20 12:13
  • by minerva9