Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
livebox:hah_hahnode:nanode_gateway [2013/06/02 05:23] – brett | livebox:hah_hahnode:nanode_gateway [2013/06/02 05:50] – [Architecture] brett | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Nanode Gateway ====== | ====== Nanode Gateway ====== | ||
- | {{ : | + | The Nanode is an RF enabled, and Ethernet enabled, AVR328P boards using the same development tools as the Arduino. |
- | What this does is it accepts | + | They are available for purchase here: http:// |
+ | |||
+ | {{: | ||
+ | |||
+ | ===== Architecture ===== | ||
+ | |||
+ | How we are going to use this it to have it pretend to be an [[livebox/ | ||
This one embedded device can replace the base jeenode + xap-serial running on the livebox. | This one embedded device can replace the base jeenode + xap-serial running on the livebox. | ||
Line 9: | Line 15: | ||
{{: | {{: | ||
- | This device acts as a pseudo xap-serial service | + | It does this by acting |
+ | |||
+ | ===== Operation ===== | ||
Once the firmware is flashed the only details that requires configuration are the NODE ID, Group and RF Frequency these must be done via the serial interface use to flash the device. | Once the firmware is flashed the only details that requires configuration are the NODE ID, Group and RF Frequency these must be done via the serial interface use to flash the device. |